Carefree FREESTYLE EVOLUTION, Owner'S Manual, Page: 7 / 16

RAGM F
REESTYLE
RM A
WNING
7
BT M
OTION
S
ENSOR
The BT Motion sensor detects awning motion caused by windy conditions. The
sensor is located inside the lead rail on the LH (motor) side.
The system operates by gauging the motion of the awning's lead rail. When the motion
exceeds the factory preset threshold the system retracts the awning. The factory
default is “3” on a scale from 1 to 5; 5 being the most sensitive. When using the mobile
app, the sensitivity can be adjusted for personal preference.
NOTICE
The Carefree auto retract system is a premier electronic auto-
retract system that provides protection against adverse elements; but no auto-
retract system is a guarantee against severe or destructive weather; the effects
of wind and rain on an awning are unpredictable and may cause severe damage
to the awning and/or vehicle. If wind or extended periods of rain are expected,
roll up the awning.
NOTE:
The auto-retract system is ON when the power switch is ON. The system is
OFF when the power switch is set to OFF. If the power is shut off with the power switch
while the awning is extended, the awning is not protected by the auto-retract system.
Battery Replacement
If the motion sensor batteries are low, the awning will beep every 30 seconds (when the
power switch is ON) and the awning will partially retract. This continues until the
batteries are replaced. The awning operates normally after the batteries are replaced.
The motion sensor uses two (2) “AAA” alkaline batteries. Batteries are available
at local battery outlets.
1. Open the awning to access the motion sensor that is located in the lead rail on the
motor side of the awning.
2. Remove the sensor module from the awning.
3. Remove the screws and the rear cover.
4. Remove the two batteries.
5. Make sure that the contact tabs are clean and bent out for best contact.
6. Insert new batteries. Match the new battery orientation with the old batteries.
Tip: Place the battery end next to the PC board first then swivel the other end into
the case. This will set the batteries firmly into the case.
7. Check that the seal is in place and flat then attach the rear cover with the
screws removed previously.
8. Install the module on the bracket.
BT017a
Remove Screws
and Cover
Remove Old Batteries
Insert New Batteries
Insert These
Ends First
PC Board (ref)
Remove Screws and
Motion Sensor From Bracket
Seal (ref)