Carefree of Colorado
Service Manual
SOKIII & S
UMMIT
052520-301r1
7
Attaching the Front Cover
SOK3025f
Latch Lever
Center Latch Pin
Detail
B
Spring-Loaded
Attach Pins
C
B
Mounting Holes
Cotter Pin
Detail
C
Center Cover
Mount
Cover Retaining Screws
Spring-Loaded
Attach Pins
Mounting Holes
Spring-Loaded Pin Attach
Threaded Screw Attach
Detail
A
A
Figure 5. Attaching the Front Cover.
1. If removed, insert the center cover mount into the deflector splice and around the rolled fabric. Secure with the
cotter pin removed earlier.
For Spring-Loaded Pin Mounts:
2. Examine the two cover halves. The RH half has spring loaded attachment pins on both ends; the second half
has pins on one end only.
3. Lift the RH cover up and set the pins into the mounting holes of the RH end cap.
4. In the center, press the pins into the cover and set into position. Adjust the position until the pins pop out
through the mounting holes of the center support.
5. Lift the second cover half up and slide the inside end onto the protruding attach pins of the first cover.
6. At the LH end cap, press the pins into the cover and set cover into position. Adjust the position until the pins
pop out into the mounting holes of the end cap.
7. Locate the latch lever at the center of the covers. Using a screw driver or similar tool, push the lever to
the left and hold; press the cover into position then release the latch lever. The latching pin is spring
loaded and will slide into the locking channel.
For Threaded Screw Mounts:
2. Examine the two cover halves. One half has spring loaded attachment pins on one end, the second
has none. Lift the first cover half with the pins and insert the pins through the mounting holes of the
center cover support.
3. Align the cover with the RH end cap and screw the cover retaining 1/4-20 x 1 1/2 socket head screws
through the end cap and into the cover. Hand-tighten only.
NOTE: If replacing the end caps: the bottom screw holes in the end caps are threaded at the
factory. It will be necessary to force-thread the top holes in the end cap using the
supplied screws.
4. Lift the second cover half up and slide the inside end onto the protruding attach pins of the first cover.
5. Align the second cover with the end cap and screw the cover retaining screws through the end cap and
into the cover. Hand-tighten only.
6. Locate the latch lever at the center of the covers. Using a screw driver or similar tool, push the lever to
the left and hold; press the cover into position then release the latch lever. The latching pin is spring
loaded and will slide into the locking channel.
Manual
Compliments
of
Northwest
RV
Supply
Printed
From
http://www.nwrvsupply.com
Table of Contents
