Carefree of Colorado
Service Manual
SOKIII & S
UMMIT
052520-301r1
5
Method 1 Spring-Loaded Pin Attach:
1.
Place the top pin of one end of the cover into the mounting hole of the end cap.
2.
On the other end of the cover, press the top pin into the cover and set the cover into position. Adjust
the position until the pin springs out and into the mounting hole of the second end cap.
3.
Repeat the procedure for the bottom pins.
4.
For covers 12 feet and longer
: Locate the latch lever at the center of the cover. Using a screw driver
or similar tool, push the lever to the left and hold; press the cover into position then release the latch
lever. The latching pin is spring loaded and will slide into the locking channel.
Method 2 Screw Attach:
1.
If removed, thread the 1/4-20 x 1 1/2 socket head screws into the end caps. On one side thread the
screws until flush with the inside of the end cap. On the other side, thread the screws until they
project out of the end cap approximately 1/2".
NOTE: If replacing the end caps: the bottom screw holes are threaded at the factory. It will be
necessary to force-thread the top holes in the end cap using the supplied screws.
2. Lift the cover up and place one end over the screws that project out of the end cap. The screws fit
into the slots of the cover.
3.
Align the cover with the other end cap and thread in all the attach screws thru the end caps and into
the cover. Hand-tighten only.
4.
For covers 12 feet and longer
: Locate the latch lever at the center of the cover. Using a screw driver
or similar tool, push the lever to the left and hold; press the cover into position then release the latch
lever. The latching pin is spring loaded and will slide into the locking channel.
Manual
Compliments
of
Northwest
RV
Supply
Printed
From
http://www.nwrvsupply.com
Table of Contents
