PRODUCT CODE
WA01082
CABLE ADJUSTER UNIT
If the tension of the brake handle is STILL too loose/tight, perform the following adjustments:
1. Figure Use fingers or a 10 mm wrench to turn the larger locking nut until loosened. Then
use fingers or pliers to turn barrel adjuster nut and try the brake. If this does not correct
the problem, repeat turning the barrel adjuster nut until the brake functions as expected.
Then tighten the locking nut until it presses tightly against the housing to prevent the
barrel adjuster nut from loosening. As shown in Figure 12.
2. Use fingers or a 10 mm wrench to turn the larger locking nut until loosened. Then use
fingers or pliers to turn barrel adjuster nut and try the brake. If this does not correct the
problem, repeat turning barrel adjuster until the brake functions as expected.
Then tighten the locking nut until it presses tightly against the fixed plate to prevent the
barrel adjuster nut from loosening. As shown in Figure 13.
CARE AND MAINTENANCE
1. Ensure that ALL attaching hardware is
secured at ALL times.
2. Check the seat rails locked into the plastic
slots securely. If not, push down the seat
again.
3. Check the wheels are locked and installed
properly.
4. Make sure the quick release kit is locked.
5. Replace any broken, damaged or worn
items immediately.
CARE OF WHEELED ACCESSORIES
1. Clean wheels with warm water and
neutral cleanser. Dry with clean rag.
2. Lubricate with 3-in-l oil periodically if
wheels begin to squeak.
FIGURE 12
FIGURE 13
0333 015 5000 | CareCo UK Limited , Hubert Road, Brentwood, Essex, CM14 4JE
