26
CR16 Installation
The CR16 is intended to be installed within the SS16 chassis. When ordering an SS16, it is possible
to have it shipped from the factory pre-installed, however if required, it can be installed on site as
well. The steps required to install it are as follows:
•
Unplug all cabling entering the SS16 from the left side of the chassis (closest side in the
photo below). If power is being provided locally, the power will also need to be removed. All
device port cabling does NOT need to be removed.
•
Using a Philips screwdriver, remove the two screws found on the device port side of the
SS16 chassis (area highlighted with RED circles in picture below).
•
Gently grasp the top and bottom edges of the cover close to the device ports and tip upward
slightly.
•
Now gently tap the entire cover to the left (opposite the device ports) until the two
mounting tabs holding the left edge of the cover are free from the base.
•
Take the CR16, and place it component side down, and align with connector P14 on the
SS16 (right behind the large device port connectors). The plastic mounting posts located on
each end of the CR16 should line up directly with mounting holes found on the SS16 board.
Snap the each mounting
post into the SS16, and
then press the center of
the CR16 to fully seat
the connector.
•
Re-install the cover, and
mounting screws.
Figure 26
Camera wiring
Composite video cameras of the customers choosing can be used with this system. All that is required is
the use of a video balun module local to the camera, as well as at the head end monitoring equipment. The
balun modules simply convert the ground referenced composite video to a balanced video signal suitable
for transmission over UTP, and then back again just before going into the central 3
rd
party monitoring
equipment (ie: Digital Video Recorder). If the system is configured appropriately, the end user can select
directly on the DA1 which camera is to be routed to the central monitoring equipment. Only one video
signal per SS16 can be active at any one time.
