6
scala rider
®
Solo
™
Standard Method
1. Use the enclosed Allen Wrench to loosen the
two screws on the Back Plate.
2. Slide the Back Plate between the internal
padding and the external shell of the helmet.
3. Adjust the clamp’s location so that the
microphone is located opposite your mouth
and then tighten the screws. You may need to
reposition the Clamp repeatedly until you
identify the best spot. The microphone must be
positioned vertically and not horizontally.
Glue Plate Method
You have the option to glue the Helmet Clamp onto your helmet,
when the above standard method cannot be used, or in case you
prefer to secure the Helmet Clamp with adhesive glue. This option
has been successfully used for a range of high end helmets.
NOTE:
While we have no reason to believe that the gluing option might
negatively affect any helmet, Cardo does not assume any respon-
sibility to that affect, irrespective of its nature and circumstances.
The Glue Plate is offered as a free option that you may choose to
use at your own risk and subject to renouncement of any future
claims.
Caution:
This process can be done only once!
1. Use the enclosed Allen Wrench to remove both
Allen screws and release the Helmet Clamp’s back
plate.
2. Determine the location on the helmet where the Hel-
met Clamp must be attached.
3. Adjust the Helmet Clamp’s location on the Helmet so that the
microphone is located opposite your mouth.
You may need to reposition the Clamp
repeatedly until you identify the best spot. The
microphone must be positioned vertically and
not horizontally (Be sure to clean the selected area prior to the
gluing process).
4. Use the pre-moistened Towelette to clean the helmet area where
you want to install the Glue Plate. Allow to dry thoroughly.
5. Peel the foil cover from the Glue Plates’ adhesive pad.
6. Place the Glue Plate into position according to #3. Press firmly 15
seconds on all 3 parts of the Glue Plate.
7. The adhesive pad bonds to full strength over the next 24 hours.
Therefore it is recommended to not use the headset during this 24
hour period.
8. Fasten the Clamp to the Glue Plate using the Allen screws that were
previously removed.
POSITIONING THE SPEAKERS
Speaker A
Speaker B
Attach the speakers to the Velcro inside
your helmet opposite your ears (short
speaker cord for the left ear [A] and the
long speaker cord [B] for the right ear).
You may want to use the supplied Velcro
pad.
Using two speakers inside the helmet
may be prohibited in certain jurisdictions. If this is the case, you
should tuck away the long corded speaker underneath the helmet
padding as follows:
