BX
50
14
2.3
Assembly
Before assembly, take a close look at the individual assembly steps shown and carry out the assembly
in the order given.
L
NOTICE
First loosely screw all parts together and check that they fit properly. Then tighten the screws
using the tool only when you are instructed to do so.
Step 1:
Mounting the rear stand
Required tools: Socket wrench and Multitool
1. Remove the pre-assembled two nuts (
J1
), two spring washers (
J2
) and two washers (
J3
) from
the rear stand (
C
).
2. Attach the rear stand (
C
) to the main frame (
A
) with the two nuts (
J1
), two spring washers (
J2
)
and two washers (
J3
) previously removed.
Summary of Contents for Ergometer BX50
