xr 600
8
the normal level of attention, feeling and reaction. The machine cannot be used without safety parts and
devices well mounted or not efficient because they could create electric risks.
3.7.
Electric requirements
Connect the machine to 220
240 volt electric circuit, frequency 50
60Hz, with plug to hearth of minimum
12 Ampere for range XR600 treadmills.
Range XR600 treadmills at normal functioning absorbs 2000 VA about.
Every machine has its electric wire and plug. The plug must be connected to a socket correctly installed on
the basis of local laws.
3.8.
Working place
The working place of the machine must have:
Temperature: from + 5 °C to + 30 °C Moisture: from 20 % to 90 %.
If the treadmill is transported or stored with temperature below 0°C and then positioned into the working
place with above mentioned temperature, please wait about 1 hour before turning it on in order to avoid the
console thermic shock.
The machine cannot be used outdoor and in rooms with fire or explosion risk. The user must be in front of
machine console. The ambient conditions cannot create uneasy situations (noise, high beam lights, etc…) or
physical and psychical stress to the user. Before installing the machine please calculate the minimum spaces
around it necessary for turning around, cleaning, service and out of hot sources.
3.9.
How to stabilize the treadmill
Check the treadmill be on stable surface and, if necessary, adjust the rear feet after that block the two M20
bolts until stability is achieved.
3.10.
How to centre the running belt
The treadmill has a belt self-centring system. If the belt goes to right or left side, please control that the
treadmill is well steady on the floor (see 3.9 how to stabilize the treadmill). To centre the belt, use the left
rear screw with moving of half a turn each time. Turning the screw rightwards, the belt will move rightwards
while turning the screw leftwards the belt will move leftwards.
3.11.
Best running belt tension
To obtain the best belt tension, put the treadmill at 5 km/h speed, hold the side handles and press the belt
with feet stopping it with difficulty and feeling the front roller slipping. If the belt is easily stopped, it means
