4
The appliance must not be installed behind a decorative door in order to avoid
overheating.
Ensure that shelves are installed with the raised barrier to the rear, in order to prevent cooking
dishes or the like
from sliding over the rear edge.
The following maintenance should be undertaken by an authori
s
ed service centre or similarly
qualified persons in order to avoid a hazard.
Connecting
a power supply cable
Opening the terminal board:
•
Using a screwdriver, prise the side tabs of the terminal board cover
open
•
Pull open the cover of the terminal board
To install the cable, proceed as follows:
•
Remove the wire clamp screw and the three contact screws L-N
and Earth
•
Fasten the wires beneath the screwheads using the following color scheme; Blue
(N)
Brown (L), Yellow- Green
(Earth)
•
Fasten the supply cable in place with the clamp and close the cover of the terminal
board.
Connecting the supply cable to the mains
When connecting the cable directly to the mains, install an omnipolar circuit-breaker with a
minimum contact opening of 3mm between the appliance and the mains. The omipolar circuit
breaker should be sized according to the load and should comply with current regulations (the
earth wire should not be interrupted by
the
circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of more than 50
°
C
with respect to the room temperature, anywhere along its length.
Before making the connection, check that:
•
The electrical safety of this appliance can only be guaranteed if the
appliance
is correctly and
efficiently earthed,
al
ways ensure that the earthing is
su
fficient
.
I
f you have any doubts call in a
qualified technician to check the system. The manufacturer declines all responsibility for
damage resulting from a system which has not been earthed.
•
Before
connecting
the appliance to the mains, check that the specifications indicated on the
dat
a
plate (on the appliance and/or packaging) correspond to those of the electrical mains
system of
your home.
•
Check that the electrical capacity of the system will support the maximum power
of
the
appliance, as indicated on the data plate. If you have any doubts, call in a qualified
technician.
