4
CONFIGURATION
The Scale has been pre-configured at the factory and should not require configuration for use in
most applications. In the event that the factory settings do not meet the requirements of your
application, the following describes the steps to configure the scale.
TO BEGIN CONFIGURATION:
1. Press the
ON/OFF
key to turn on the scale.
2. Press and hold the
ZERO
key for 3 seconds. When the display shows
+5<
, release the
ZERO
key to enter the Configuration mode. The display will change to show
(1.<
.
WEIGHING UNITS
To select “lb/OZ” (pounds/ounce) weighing units:
1. With the display showing
(1.<
, press the
ZERO
key. The display will change to show
both “lb” and “OZ”.
2. Press
ZERO
key to display lb/OZ status.
3. Press the
UNIT
key to toggle between:
Enable (display will change to
$1
) or
Disable (display will change to
$
).
4. Press the
ZERO
key and then the
UNIT
key 5 times. The display will change to
(1.<
.
5. Proceed to AUTOMATIC SHUTOFF.
To select “OZ” (ounce only) weighing units
1. With the display showing
(1.<
, press the
ZERO
key and then the
UNIT
key. The
display will change to show “OZ”.
2. Press the
ZERO
key to display OZ status.
3. Press the
UNIT
key to toggle between:
Enable (display will change to
$1
) or
Disable (display will change to
$
).
4. Press the
ZERO
key and then the
UNIT
key 4 times. The display will change to
(1.<
.
5. Proceed to AUTOMATIC SHUTOFF.
To select “1/4 OZ” (fractional ounce) weighing units:
1. With the display showing
(1.<
, press the
ZERO
key and then the
UNIT
key 2 times.
The display will change to show “OZ” and “1/4”.
2. Press
ZERO
key to display 1/4 OZ status.
3. Press the
UNIT
key to toggle between:
Enable (display will change to
$1
) or
Disable (display will change to
$
).
4. Press the
ZERO
key and then the
UNIT
key 3 times. The display will change to
(1.<
.
5. Proceed to AUTOMATIC SHUTOFF.
