8525-M316-O1 Rev A
x
8435(KG)
4
BATTERY OPERATION
Batteries
The scale can use 6 "AA" size Alkaline, Ni-Cad or NiMH batteries (
not included
). You must
first obtain and install batteries before operations can begin. Batteries are contained in a
battery holder inside indicator. Access is via a removable panel on the back of indicator.
When using batteries, all 6 batteries must be of the same type. They must be all Alkaline,
Ni-Cad or all NiMH. In addition,
DO NOT
mix Ni-Cad or NiMH batteries.
IMPORTANT!
The scale can be operated from Alkaline, Ni-Cad or NiMH batteries.
All six (6) batteries must be of the same type. They must all be Alkaline, all Ni-Cad
or all NiMH.
DO NOT
mix Alkaline and Ni-Cad or NiMH batteries.
CAUTION!
The AC power adapter is also used to recharge the batteries, when the
scale is operated from Ni-Cad or NiMH batteries.
DO NOT
connect the AC power
adapter to the scale if using Alkaline batteries. Also, when using Alkaline batteries,
make sure
niCAd
setup option is disabled (set to 0). Refer to Setup and Calibration
or Setup Review sections of 750 Weight Indicator Owner’s Manual (8555-M260-O1).
Battery Installation/Replacement
To install or remove the batteries, the following steps should be followed:
1.
Make sure the AC power adapter is
unplugged.
2.
Remove the indicator from scale column
bracket. (Referring to Figure No. 3, pull
the spring plunger down and slide the
indicator up away from the bracket).
3.
Turn the indicator over so that the display
is facing away from you.
4.
Locate the rectangular panel on back of
indicator.
Battery Cover
5.
To install or replace the batteries, first
remove the battery holder cover by
pushing in on the tab and lifting it up.
Refer to Figure No. 4.
Load Cell Cable
AC Power Adapter
Spring
Plunger
Release
Figure No. 3
Push in and
lift here.
Figure No. 4
For more information on setup and
operation of the indicator, see the
750 Owner’s Manual (8555-M260-O1).
Summary of Contents for Detecto 8435
Page 2: ......
