8200-M535-O1 Rev B
225-DS
12
INDICATOR SETUP, CONT.
9. TOTALIZE=XXX
(SCALE TOTALIZER)
With the 225-DS (Dual Scale) Card installed and the number of scales set for 2 or 3, the 225
can sum the weights of two or more scales and make the total available to be displayed.
The totalizer can be referenced as if it were another scale.
NOTE!
The totalizer's scale
number will always be 4 regardless of the actual number of scales attached to the indicator.
With SETUP MENU #1 displayed the current setting for the
TOTALIZE=
parameter
will be shown. Note that XXX is the current value. If the setting displayed is acceptable,
proceed to the next setup parameter.
Otherwise, press the
9
key, the
ENTER
key,
YES
or
NO
(on the soft keys) and then the
ENTER
key to save the new setting and return to SETUP MENU #1.
10. MODE OF OP=X XXXX
(MODE OF OPERATION)
IMPORTANT!
The
Mode Of Op
is limited to options
0. NORM
(Normal Indicator),
1. IDS
(ID Storage) or
3. Preset Weight Comp
(Preset Weight Comp).
Refer to the 225 Weight indicator Installation and Technical Manual, 8200-M538-O1, for
information and instructions on Mode of Operation.
SETUP MENU #2
With SETUP MENU #1 displayed, press
NEXT
(Navigation Keys
Down Arrow) to
proceed to SETUP MENU #2.
SETUP MENU #2
1. SERIAL 6. SETUP SCALE 2
2. DIO 7. CALIBRATE 2
3. PRINT TABS 8. SETUP SCALE 3
4. SETUP SCALE 1 9. CALIBRATE 3
5. CALIBRATE 1 10. TOT CAP=XXXXXXX
Enter Selection: 0
`
NEXT
^
PREV
Parameters 8 and 9 will only be shown if 3 has been entered for the number of scales.
IMPORTANT!
If YES was selected for the
TOTALIZE
parameter (refer to SETUP
MENU #1), then the following parameter will be shown on SETUP MENU #2.
Summary of Contents for 225-DS
Page 2: ...8200 M535 O1 Rev B 225 DS 2...
Page 19: ...8200 M535 O1 Rev B 225 DS 16...
Page 20: ...8200 M535 O1 Rev B 225 DS 17...
