Cardin RPQ504T10, Set Up And User Instructions

Page: 13 / 52

13
Transmitters
The transmitter is pre-coded and is fitted with an integrated circuit which is programmed in the factory
with a unique identification number. All the code parameters are contained in this integrated circuit. The
transmitter has an automatic shut down mechanism which cuts in after at least 20 seconds of continuous
use (this limits battery consumption).
Key block function
• A key block function has been added to protect the appliance from accidental
activation:
- to activate the function press and hold down “
MR
” for 8 seconds until the red
led starts flashing, at this point to activate a command you will need to press
the required key three times consecutively;
- to reset the function to standard operation standard press and hold down
“
MR
” for 8 seconds until the orange led starts flashing.
Installation
Depending on the type of installation, work out the position in which the interface will be situated
remembering that the site must be indoors, in a position safe from accidental collision and in a position
which the technician can easily reach.
• Using the container as a template mark the two points at which the fastening holes are to be drilled and
fasten down using two self-tapping
M4
screws and relative rawplugs.
1
2
MR