Part number 3E1100 R16
5
July 2010
Please note that the manufacturers warranty is voided if the electronics are
damaged as a result of the incorrect screws being used or installed incorrectly
to secure the base.
Push the socket back into the grommet.
Push the grommet and socket firmly back into the Prox Mifare Series
(Teardrop) reader base so that the top of the grommet is slightly below the
inside surface of the reader base.
Install the PCB assembly into the base.
Fit the facia onto the base by clipping the small lip, inside the facia, over the
top edge of the base and holding the top, press the bottom of the facia down
over the base. If the cover does not fit easily, recheck the position of the
grommet and/or the reader. Then insert the M3 x 16 Torx Security Screw
(using an M3 Torx Post Security screwdriver) through the hole at the bottom of
the facia and into the threaded metal insert in the base to secure the facia.
Removal of the facia is a simple reversal of these steps.
