13
Pairing a Replacement Remote Control
Your CARBINE system remote controls are already paired to the
control module. If you are replacing or adding remotes to your
system, they must be programmed (paired) to the control module
before they will operate the system. In order to perform remote
control pairing, you must know where your “Receiver/Control Center
(RCC) is as you will use the button and the LED indicator to perform
the pairing function.
Remote Pairing Procedure
1. Open the driver’s door.
2. Insert the ignition key into the key cylinder.
Turn ON the ignition key
3. Press and release the valet button then press and hold the valet
button for 1.5 seconds. The LED flashes and the horn chirps
(if connected). Release the valet button. The system will stay in
Pairing mode for 60 seconds.
5. Press and hold the button on the new remote control.
6. Press and
release
the
button 5 times. The LED on the remote
will begin a steady flash. Release all buttons. The LED
will flash for 15 seconds.
7. Press and
release
the button on the new transmitter.
The horn/siren chirps and the LED flash pauses to indicate
that the new remote is programmed.
8. Turn the ignition key to the Off position. A long chirp from the
horn confirms that the pairing mode is off.
Note:
Your CARBINE security system will accept codes from
up to (4) transmitters.
Summary of Contents for 46CR
Page 1: ...1 O W N E R S M A N U A L...
