Fig 7
Fig 8
16
4A
Initial Assembly
10
Adjusting bolt
Table supporting brackets assembled
Fig 5
Fig 6
9
7
Locate the remaining three panels
(2)
and 20 No.
M8x16mm
(5B)
bolts, nuts and double washers.
Take up the rear panel with the dust extraction
moulding fitted and fit between the rear legs,
using washered bolt through the leg and panel
and securing with washer and nut. Again, secure
the nuts finger tight only. (See fig 7)
With easy open access, now is a good time to fit the
dust extraction hose. Locate the hose
(4A)
and the
two 125mm hose clips
(16)
. Stretch the hose out to
its full length. Slip the hose clips over the ends of
the hose, fit the hose to the outlet on the saw box
and the dust extraction moulding and tighten the
hose clips to clamp them in place. (See figs 8-9-10)
Fit the hose over the dust extraction
moulding and clamp in place
Fit the hose over to the saw box outlet
and clamp in place
Fig 9
Fig 10
Fit the remaining panels to the legs, using the same
securing sequence. Wriggle, push, pull, press, lever
etc., the legs and the panels into the best alignment
with the upper chassis and tighten the nuts and
bolts using the spanners provided. (See figs 11-12)
Fig 11
4A
16
