Carbatec SS-400H, Manual

Page: 7 / 36

CARBATEC.C OM.AU
SS-400H
Operating a power tool can be dangerous
if safety and common sense are ignored.
The operator must be familiar with the
operation of this machine. Read this manual
to understand this machine. DO NOT operate
this machine if you do not fully understand the
limitations of this tool. DO NOT modify this
machine in any way.
BEFORE USING
THIS MAC HINE
!
To avoid serious injury and damage to the
tool, read and follow all of the Safety and
Operating Instructions before operating
the machine.
!
1. Some dust created by using power tools
contains chemicals to cause cancer, birth
defects, or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints.
• Crystalline silica from bricks,
cement, and other masonry
products.
• Arsenic and chromium from
chemically treated lumber
Your risk from these exposures varies,
depending on how often you do this
type of work. To reduce your exposure to
these chemicals: work in a well ventilated
area and work with approved safety
equipment, such as those dust masks
that are specially designed to filter out
microscopic particles.
2. READ the entire Owner’s Manual.
LEARN how to use the tool for its
intended applications.
3. GROUND ALL TOOLS. If the tool is
supplied with a 3-prong plug, it must
be plugged into a 3-contact electrical
receptacle. The 3rd prong is used to
ground the tool and provide protection
against accidental electric shock.
4. AVOID A DANGEROUS WORKING
ENVIRONMENT. DO NOT use electrical
tools in a damp environment or expose
them to rain.
5. DO NOT use electrical tools in the
presence of flammable liquids or gasses.
6. ALWAYS keep the work area clean, well
lit, and organized. DO NOT work in an
environment with floor surfaces that are
slippery from debris, grease, and wax.
7. KEEP VISITORS AND CHILDREN AWAY.
DO NOT permit people to be in the
immediate work area, especially when the
electrical tool is operating.
8. DO NOT FORCE THE TOOL to perform
an operation for which it was not
designed. It will do a safer and higher
quality job by only performing operations
for which the tool was intended.
GENERAL SAFETY
SAFETY INSTRUCTIONS
7