Carbatec SS-400H, Manual

Page: 20 / 36

FOR TEC HNICAL SUPPOR T CALL 1800 658 111
SS-400H
B. PINNED SAW BLADE
Fig. 7-11
Pinless blade chucks are not required for
pinned blades. Store your pinless blade
chucks in a safe place for re-use.
B1 Saw blade removal
Fig. 7 + 8
• Extract the saw-blade by sliding the
table’s insert up, then lift up the blade
tension lever (I).
• Slightly press the upper arm (M) down
(fig. 10).
• Then remove the saw blade by pulling it
forward out of the supports and through
the access in the table.
B2 Inserting the saw-blade
Fig. 7, 9-11
• Put the saw-blade into the lower support,
the other end into the upper support.
• Slightly press the upper arm (M) down
(fig 10) before hooking it in.
• Tighten the blade with the tightening
screw (I)(fig.7) By lowering the tensioning
lever. Rotate the lever clockwise to further
tension the blade.
Note: Blade teeth on most scroll saw blades
should be facing down towards the table.
CHANGING THE SAW BLADES
M
Fig. 9
Fig. 10
Fig. 11
20