Carbatec SBW-6300, Operation Manual

Page: 15 / 32

p.15
Blade changing
(1) Unplug power cord.
(2) remove the table insert and table pin.
(3) Loosen the upper & lower blade guide system.
(4) Release the saw blade with quick change saw blade system on the rear of band saw ( Fig.12 ).
(5) take out the saw blade and guide the new one through table slot,
place blade in upper and lower blade
guide system.
(6) replace the new blade in the middle of upper and lower wheel.
(you can blade tracking from the tracking window)
(7) replace the table insert and table pin.
(8) to adjust the blade tension if the blade width is different from the old blade.
Adjusting upper and lower blade guide system
(9) Dust collection
The band saw is recommended to connected to dust collector, to attach the 4" hose with steel clamp
( Fig. 15 ).
(10) Miter Gauge
i Placed the miter gauge in he table slot
ii Loosen the clam screw on the miter gauge
iii Adjust the desired angle of cutting
iv Tighten the clamp screw
Fig. 5
Fig. 6
Fig. 7 Fig. 8 Fig. 9 Fig. 11 Fig. 12
Fig. 13 Fig. 14 Fig. 15
Fig. 1
Fig. 2 Fig. 3