Manual for Tire Pressure Monitoring System, TPMS
5/21
Wireless Transmitter Sensor Installation
Step
Operation Process
Photograph
1
Use a jack to raise the vehicle and place jack stands
underneath the vehicle for safety. Refer to vehicle owner’s
manual for full service advice. Seek the assistance of a
qualified motor mechanic if required.
2
Take off the tires and bleed the air. Then take off the air
valve of the tire from the wheel.
(NOTE: You must change
the valve to TPMS valve)
. This part of the process will
normally require the service of a tire fitting service or
mechanic.
3
Recognize the number on each sensor (D)
with position of
tire on the vehicle. (VERY IMPORTANT)
a.
RF – 1
= Right Front, No. 1
b.
RR – 2 = Right Rear, No. 2
c.
LR – 3
= Left Rear, No. 3
d.
LF – 4
= Left Front, No. 4
4
Set up the new TPMS special valve (E) in the wheel.
Use wrench to fix the valve, and then tighten nut to
40~45kgf-cm (4~4.5Nm).
5
Use the new TPMS special Nylok screw (F) to tighten the
transmitter sensor into the valve on the wheel.
Torgue value must be 40~45kgf-cm (4~4.5Nm).
D
E
F
Summary of Contents for TPMS CRX-1001
Page 1: ...MANUAL TPMS CRX 1001...
