Version 27.08.2021
HW: CAM(V100)/(V20)
RL4-MIB100
P
a
g
e
17
2.5.1.
Audio-insertion
This interface is only able to insert video signals into the factory infotainment. If an AV-
source is connected, the audio insertion has to be done by the factory audio AUX input or an
FM-modulator. The inserted video-signal can be activated simultaneously to each audio-
mode of the factory infotainment. If 2 AV sources shall be connected to the infotainment,
additional electronic is necessary to switch the audio signals.
2.5.2.
After-market front camera
The red power supply output
ACC/front cam out 12V (max 3A)
can be used to power
a front camera. If Dip 1 is set to ON (black 8 dips), the power supply output gives
+12V (max 3A) when reverse gear is engaged …
incl. 10, 15 or 20 seconds delay after reverse gear is
disengaged (refer also to chapter “picture settings).
Note: In addition, a manual switch-over to the front camera input is possible via keypad (short
press) from any image mode. The power supply output gives +12V then, as well (if Dip 1 is set
to ON and the front camera input is selected).
Attention: A long press of the external keypad push button will switch the interface to the
next source.
