16
2. Check the straightness of the diamond cutting blade.
In case of doubt contact your supplier.
3. In case of oscillation by clearance on the bearing
or a crooked shaft, contact the supplier. Working with
a swinging blade can lead to dangerous situations.
The diamond cutting blade cuts too slowly.
1. Check the saw depth. Cutting in concrete or stone has
to be done in steps of 2,5 to 5 cm. Depending of the
hardness of the stone (medium hard, abrasive stone
material) a 5 until 8 cm saw depth is possible.
2. The diamond cutting blade is blunt. The diamond
grains are worn out and not sticking out of the metal
bonding. Check this by scratching your nail at the
edge of the diamond cutting blade. In case of a blunt
blade you feel a polished surface. You can easily
solve this problem by making some cuts into an
abrasive stone material. A special grindstone is
available.
The diamond cutting blade gets blunt from:
1. The power of the motor can go down by using
extension cables. The saw speed also goes down and
the diamond cutting blade becomes blunt. Do not use
extension cables longer than 30 meter. A minimum
thickness of 2,5 mm² is necessary. In case of using
cable drums these need to be unrolled completely.
2. The type of blade is not suitable for the material to be
sawn. You need a different kind of blade for cutting
concrete or hard stone and cutting abrasive materials.
Please contact the supplier for a professional advice.
3. The direction of the rotation of the diamond cutting
blade does not correspond with the direction on the
machine. Depending on the time length of the incor
rect use, the direction of the diamond cutting blade
must be changed or contact the supplier for a profes-
sional advice.
4. The diamond cutting blade does not rotate centrical-
ly. By pushing the diamond cutting blade into
the material, the diamond textures will break and
the diamond cutting blade becomes blunt. When
the diamond cutting blade is worn out eccentric the
manufacturer has the possibility to make it centric
again.
WARRANTY
For the machine, a guarantee period of 12 months applies
from the moment of delivery. Guarantee claims must be
shown by submission of purchase invoice. The guarantee
includes the repair of defects which have occurred and can
be linked by to material or manufacturing faults.
Not covered by guarantee:
Not covered by guarantee:
• Defects or damages which have arisen due to incorrect use
or connection.
• Machine overload.
• When maintenance has been carried out incorrectly or
badly.
• Information in the manual has not been properly
followed.
• The machine is used by unqualified persons.
• If the machine is used for purposes for which it is
unsuitable.
• The machine is repaired using unoriginal parts.
• If the machine encryption is damaged or deleted.
• If defects are caused by fire, damp and/or transport.
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product
is in conformity with the following standards or standard-
ized documents:
EN 60745-1; EN 61000; 2006/42/CE; 2014/30/CE; 2002/95/CE
• EN 12100:2010
• EN 14121-2:2012
• EN 13857: 2008
• EN 1005-2: 2003
• EN 1005-4: 2005
• EN 60204-1:2006
• EN 60529:1992/A1:2000
• EN 61000-6-2: 2005
• EN 61000-6-4:2006+A1:2011
Director: C.J. van Beek
01-02-2021
CARAT Nederland B.V.
Nikkelstraat 18, 4823 AB Breda, Nederland
