Car-O-Liner Group AB
BenchRack
38
32163, EN- rev. 5,
2018-04
4.4.3
Driving on/Setting up a vehicle without front or rear sub frame or wheels
Illustrations below show the recommended way to set up the vehicle by
using the T48 Support stand.
IMPORTANT
! It is not recommended to to use the T48 on top of the drive
on ramps. Risk of falling off from the ramps.
1.
Start to roll the vehicle on the T48, with no ramps on the bench.
2.
Fit first side ramp and drive on ramp to the bench. Continue to roll
on the vehicle and fit additional side ramps. Pay attention when
rolling the T48 wheels over the cable/hose protection!
3.
Gently raise the bench to the highest position with vehicle on T48
support stand.
4.
Fit two pillar jacks according to picture (right and left side of the
vehicle). Remove the T48.
Adjust the position of the pillar jacks for a suitable lifting point.
IMPORTANT!
Use B57 Roll stop to prevent the vehicle from rolling.
Cable/hose protection
Summary of Contents for BenchRack 4200
