Version 16.02.2017
CI-RL2-N900
P
a
g
e
6
1.3.2.4.
Monitor selection (dip 7-8)
Dip 7 and 8 customize the monitor-specific video settings which sometimes even vary within
head units of the same version, caused by different monitor specifications. It is necessary to
try all possible combinations (both OFF, both ON, 7 OFF and 8 ON, 7 ON and 8 OFF) while a
working video source is connected to the chosen input of the interface. One of the four
combinations will show the best picture size and quality (some may give no picture). It is
possible to first hot plug through the dip combinations. If there is no change of the picture
visible after trying all 4 options, retry and disconnect the 6pin power plug of the Interface-
box between every change of the dip setting.
1.4.
Dip-switch settings of the CAN-box
By using the Dip-switches the factory Head-Unit or vehicle
can be chosen, which the interface will be connected to.
Dip position down is ON and position up is OFF.
Vehicle/Navigation
Dip 1
Dip 2
Dip 3
Dip 4
Opel vehicles
ON
OFF
OFF
OFF
Cadillac vehicles
OFF
OFF
OFF
OFF
After each Dip-switch-change a power-reset of the Can-box has to be performed!
2.
Installation
To install the interface, first switch off the ignition and disconnect the vehicle’s battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
If the necessary stabilized power supply for the interface is not taken directly from the
battery, the chosen connection has to be checked for being constantly stabile.
The interface needs a permanent 12V source!
2.1.
Place of installation
The interface is built to be installed on the backside of the factory monitor.
