Version 27.08.2021
HW: CAM(V100)/(V20/V30)
CI-RL4-MIB92
P
a
g
e
20
2.6.
Picture -, guide-lines- and PDC settings
The picture settings are adjustable by the 3 push-buttons at the rear-side of the video-
interface. Press the MENU button to open the OSD settings menu or to switch to the next
menu item. Press UP and DOWN to change the selected value. The buttons are placed inside
in the housing to avoid accidental changes during or after the installation. Picture settings
must be done separately for all video inpouts while the corresponding input is selected and
visible on the monitor.
Note:
The OSD menu is only shown when a working video source is connected to the
selected video-input of the interface.
The following settings are available:
Contrast
Brightness
Saturation
Position H
*
(horizontal)
Position V
*
(vertical)
H-SIZE (Image width)
V-Size (Picture height)
*
If the vertical and horizontal picture position is not shown correctly on the display, it can
only be adjusted in the menu if Dip-8 (the black 8-dips) was previously set to ON.
Note:
If the video interface does not receive the required information from the vehicle CAN-
bus, neither moving guide-lines nor PDC will be supported.
