Version 26.02.2018
HW25 (V92)
CI-VL2-N902
P
a
g
e
7
2.
Installation
To install the interface, first switch off the ignition and disconnect the vehicle’s battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
If the necessary stabilized power supply for the interface is not taken directly from the
battery, the chosen connection has to be checked for being constantly stabile.
The interface needs a permanent 12V source!
2.1.
Place of installation
The interface is built to be connected at the factory navigation blackbox.
The Built-in Locations of the factory navigation blackbox may vary, even in one and the same
vehicle’s series! Please ask for the manufacturer’s information to avoid removing the wrong
parts.
The
Opel Mokka X
blackbox is usually to be found
behind the infotainment and
navigation monitor
.
The
Opel Astra K
blackbox should be found directly
behind the instruments
, like
shown below.
The
Corvette
HMI module is located in the
driver’s footwell in front of the A-pillar
.
Other Built-in locations of the blackbox like in in the passenger’s foot well in front of the A-
pillar or even behind or near the glove box are possible.
Example: location of the Opel Astra K factory blackbox
