Version 24.01.2023
HW: CAM(V100) / (V30)
CI-RL4-UCON10
P
a
g
e
8
1.5.
Settings of the 4 Dip switches (CAN functions – red)
Dip position down is ON and position up is OFF.
vehicle/Head-Unit
Dip 1
Dip 2
Dip 3
Dip 4
All vehicles
OFF
↑
OFF
↑
OFF
↑
OFF
↑
After each Dip-switch-change a power-reset of the video interface has to be performed!
1.6.
Settings of the 2 Dip switches (selection head-unit - black)
The 2 dip switches on the upper side of the interface box are used to select the head
unit.
Warning! Dip position up is ON and position down is OFF (vice versa to the black 8 dips and
the red 4 dips).
vehicles
Dip 1
Dip 2
Jeep Compass
ON
↑
OFF
↓
Fiat Ducato
ON
↑
OFF
↓
Fiat 500
OFF
↓
OFF
↓
Note:
In case the CAN functions according to this table do not work, also try the other dip
switch combinations.
After each Dip-switch-change a power-reset of the video interface has to be performed!
2.
Installation
To install the interface, first switch off the ignition and disconnect the vehicle’s battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
As with any installation of retrofit equipment, a stand-by test is neccessary after the
installation of the video interface, to ensure that the unit also switches off after reaching
the vehicle‘s sleep mode.
Before the final installation, we recommend a test-run of the interface. Due to changes in
the production of the vehicle manufacturer, there’s always the possibility of
incompatibility.
2.1.
Place of installation
The interface is supposed to be installed at a suitable location behind the vehicle`s head-
unit.
