Step
4 Loosen the fixing screw (or locking ring
)
to adjust the
position and image so that the camera faces the monitored
area, then tighten the fixing screw (the locking ring), as
shown in figure 3-3.
F
igure
3
-
3
Adjusting the monitoring direction
You can route cables from the top or from the side. If you use the top
routing method, drill a hole in the surface first. If you use the aside
routing method. When you route cables from the side. Please route
the cable out from the side gap at the bottom of the camera.
NOTE
Step
3
Install the camera on the ceiling or wall, and fix the screws
as shown in figure 3-2.
Figure 3-2
Installing camera
Step 5 (This step is applied for MF products only).
Figure 3-4, adjust view angle and focal length by using
an adjusting tool.
Installation
Steps
:
Step 1
Stick the Installation location sticker on the ceiling or wall,
Drill three holes based on the marks on the sticker. Drive
the swell plastic buttons into the holes, as shown in figure
3-1.
The Bullet HDVI Camera can be installed on the ceiling or wall. If
the camera is installed on a concrete wall, install the plastic anchors
before installing the bracket. If the camera is installed on a wooden
wall, use self-tapping screws to install the bracket directly.
3 Device
Installation
Figure 3-1
Installing camera
Step
2
Connect the Power and video cable.
Fixing screw
Fixing screw
ZOOM
FOCUS
Figure 3-4
Adjusting the view angle and focal length
196.4
7
6
.5
5
8
.4
87.2
∅58.4
5
.5
2
0
.8
2
0
.8
3-
∅4.7
Figure 2
-
4
Fixed focus Dimensions 2
（
Unit: mm
）
