damage (including vibration or bending, for
example).
5.2
Install protector SCP-6 (optional)
►
Clean the area above the switch. The bonding
surface must be free of dust, grease, oil,
silicone and separating agents.
►
Remove the film on the adhesive strip from
the back of the protector and position it above
safeCAP SC30.
►
Press down firmly on the entire surface of the
protector.
5.3
Install safety relay 3SK1 (optional)
TIP
More detailed information can be found in the supplier documentation.
5.4
Connect safeCAP SC30 to safety relay 3SK1
The lines between safeCAP SC30 and the safety
relay must be laid separately of other signal paths
or live lines.
►
Disconnect the system from its voltage supply.
►
Set the DIP switch (2). The position of the DIP
switch is indicated in the circuit diagram.
►
Connect safeCAP SC30 to the safety relay
using a 4-pin M 12 cable according to the
circuit diagram. The optional cables LKW 40-5
(5 m) / LKW 40-10 (10 m) or LKG 40-5 (5 m) /
LKG-40-10 (10 m) can be used.
10/25
1.1
safeCAP SC30
Original operating instructions
