C 0503 / GH-503U
ANIMAL REPELLER « FROGGY SHAPE » EN
Warning:
Please read this instruction manual carefully before using the
instrument and keep it for future use.
1.
PIR Ultrasonic Animal Repeller
The PIR (Passive Infra Red) Ultrasonic Animal Repeller is a safe and humane way to keep
unwanted animals out of your garbage bin, garden or out of your yard.
2.
Installation
Install the spike so the Repeller will point in the direction most traveled by animal
pests. Assemble the three piece stake and push it 10 cm into the ground. Use a rubber
mallet only if the ground is hard. Be careful not to damage the top.
Avoid placing unit behind any large trees, wall or object otherwise light sensor may not works
well and device will switch to night mold.
3.
Mount the unit to the top of the stake.
4.
The Repeller can also be attached to a flat vertical surface such as a wall.
5.
Operation
a)
The "Animal Repeller requires 4 AA batteries (Not included) Remove the two screws
holding down the battery cover. Locate the batteries and observe correct polarity. Replace
the battery cover and tighten the screws.
b)
Mode
- Day Mold
: Select the Day Mold, the unit working at the sound function only in day time. Sound
and flash light will working same time in night time.
- Night Mold
: Select the Night Mold, the unit will work in sound function only in day time and flash
light will working only in night time.
When the InfraRed sensor detects motion the ultrasonic speaker and LED light will
activate. The ultrasonic speaker will sound for 5 seconds and the LEDs will flash on and 0 .
After this, the repeller will return to stand-by mode.
Caution
Allow the Animal Repeller to operate continuously for best results.
Do not immerse repeller in water.
Do not cover the Passive InfraRed sensor.
