15.2 OVERFLOW WATER
INDICATOR (fig. 13b)
After brewing coffee, the machine
automatically releases the pressure of
the brewing chamber together with
some water into the tray. If too much
water collects in the tray the little red
indicator will pop up. Pull out the tray,
remove the used coffee container and
the water level indicator. Then empty
tray and the used coffee container,
place all the parts back into the tray,
and insert tray back into the machine.
15.3 REMOVING THE CAROUSEL
For proper cleaning you can remove
the carousel as follows:
a.
The lever should be in the raised
position.
b.
Turn the lever to the back of the
machine so that the carousel
release button points to the front
(see fig. 15).
c.
Push the button and lift the
carousel (see fig. 16).
d.
Hold the carousel upside down and
clean under running water
(see fig. 17).
e.
Replace the carousel in reverse
order. Make sure that the release
button points to the front of the
machine. Make sure that the lever
is in the raised position before
placing the carousel back onto the
machine.
DO NOT PLACE THE CAROUSEL IN
THE DISHWASHER!
15.4 CLEARING THE THERMOCOIL
The internal ThermoCoil system holds
a small amount of water. If you do not
use the machine for a prolonged time
(a week or longer) or if you plan to
move the machine or send it to anoth-
er place the ThermoCoil should be
empty. This procedure takes approxi-
mately 90 seconds.
a.
Turn the machine on.
b.
Fill a large pitcher with cold water
and immerse frother into pitcher.
c.
Turn the selector switch to the
steam symbol. Steam will be
released for about 80 seconds.
When the steam stops, the
ThermoCoil system is cleared.
d.
Turn the selector switch back the
spout symbol and turn machine off.
Important:
The next time you use the
machine, follow the instructions under
chapter 6 first.
15.5 DECALCIFYING
CAUTION
: DO NOT USE ANY COM-
MERCIAL DECALCIFYING AGENT.
DO NOT USE DURGOL. Any highly
re-active cleaning solution might
destroy the internal brewing chamber.
Use a water/vinegar solution only.
If you use your machine daily we rec-
ommend decalcifying every 4 to 6
weeks as follows. This procedure will
take about 15 minutes.
a.
Fill the water tank with 20 oz. of
water and approx. 10 oz. of vinegar.
b.
Turn the machine on and place a
large cup or container underneath
the coffee spout.
c.
Pump approx. 5 oz. of the solution
through the coffee spout.
d.
Stop the pump, wait for one minute.
e.
Repeat three of four times.
f.
Then place a large container under-
neath the frother.
g.
Turn the selector switch to the hot
water symbol and turn on the pump.
h.
Pump approx. 3 oz. of the solution
through the frother.
i.
Stop the pump, wait for one minute.
j.
Repeat twice.
k.
Now empty the water container and
clean it thoroughly so that there is
no vinegar residue left in the water
container.
l.
Fill the water container half full with
fresh cold water.
m.
Pump half of the water through the
coffee spout and the other half
through the frother using the hot
water setting.
n.
Turn off the machine. Remove tray
and clean all parts of the tray.
9
