Before First Use
Read all Important Safeguards and below operating instructions before using
this kettle. Discard the first filling of heated water to remove any dust and
residues from the manufacturing process.
Heating Water
1.
Remove kettle from the Power Base using the Handle (Fig.1).
2.
Grip the Lid Knob and pull upwards to take off the Removable Lid (Fig.1).
3.
Fill with the desired amount of fresh, cold water. The kettle has internal
minimum and maximum markings. Never under fill or overfill the kettle (Fig.3).
CAUTION / DANGEROUS:
Never fill above the MAX line! If you fill above
the MAX line, hot or boiling water will push out of the Spout or Removable
Lid. This can cause severe injuries and burns. Never fill below the MIN line
initially or replace an empty kettle on the Power Base during Keep Warm.
Always make sure the water level is above MIN marking when the kettle is
warming or heating. Placing an empty kettle onto the Power Base during
heating or keep warm can cause damage to the heating element.
4.
Replace the Lid and ensure it is securely locked in place (Fig.1).
5.
Place the kettle back on the Power Base.
6.
Plug cord into outlet, the ON/OFF button will flash red once and then shut off
(Fig.2). The kettle will beep and the display shows the default settings of
195°F and 4:00 minute countdown (Fig.4). The kettle is now in stand-by mode.
IMPORTANT:
The kettle can be set for either Fahrenheit or Celsius
temperature scales. To switch between temperature scales push the
– and + buttons at the same time while the kettle is in stand-by mode (Fig.2).
7.
Set the heating temperature by first pushing the Temperature button (Fig.2)
then adjust the temperature in 1° increments using the – or + buttons. The
kettle can be set between 140°F - 212°F or 60°C - 100°C. You can press
and hold either the – or + buttons to advance the temperature more quickly.
8.
Once the desired temperature has been set, push the Temperature button
again. If the button is not pushed after 5 seconds the temperature setting on
the display will lock automatically.
NOTE:
You may also change the temperature setting after you have started
the heating cycle. Simply push the Temperature button (Fig.2 during the
cycle and the display will switch from the actual temperature to the set
temperature (Fig.4). Using the - / + buttons, change the set temperature
accordingly. Once the desired temperature is reached push the Temperature
button to lock in the setting as the water continues to heat.
9.
Once the temperature is set, push the ON/OFF button. There is a short
beep and the ON/OFF button blinks red. The display will show the actual
temperature as the water begins to heat and the ON/OFF button will continue
to blink. The warmer the water becomes the more you will hear the noise of
the water heating up.
10. Once the programmed temperature has been reached the ON/OFF light will
stop blinking and the kettle will beep.
11. Lift the kettle from the base and pour the water carefully.
12. Replace the kettle back onto the Power Base. If the kettle is left idle for over
one minute, the display will transition to sleep mode and turn off.
NOTE:
To activate the display, push any button or remove and replace
the kettle from the Power Base.
6
