30
31
Instruction manual WMi4000
Instruction manual WMi4000
Please keep this instruction manual for future reference
Please keep this instruction manual for future reference
S U G G E S T I O N S F O R M OV I N G O R P R O L O N G E D D I S U S E
Should the washing machine be stored in an unheated room for a long period of time, drain all
water from tubes.
Unplug the washing machine.
Detach the tube from the drainage system and clip on the rear of the machine and lower it,
fully draining water into a bowl.
Secure the drain tube with the drainage system and clip on the rear of the machine
when finished.
Keep the door glass and gasket clean.
The manufacturers warranty only covers faults within the product of a mechanical or electrical
nature. Faults caused by handling, installation or misuse are not covered and may incur a
charge for any repair visit to resolve.
T R O U B L E S H O OT I N G
B E F O R E C A L L I N G F O R S E RV I C E
Reviewing the charts on the following pages may save you from calling for service.
E R R O R C O D E F O R M AT
MODELS WITH A DISPLAY:
The error is shown by a number preceded by the letter “E”
(example: E2 = Error 2).
MODELS WITHOUT DISPLAY:
An error is shown by a sequence of flashes of every LED. The
error code is shown by the number of flashes followed by a pause of 5 seconds (example: two
flashes – pause 5 seconds – two flashes – repeating = Error 2).
E R R O R S H OW N
P O S S I B L E C AU S E S A N D P R AC T I C A L S O L U T I O N S
E2 (with display)
2 flashes of the LEDs
(without display)
The machine cannot load water.
Make sure the water supply tap is open.
Make sure the water supply hose isn’t bent, kinked or trapped.
Make sure the drain pipe is at the proper height (see installation section).
Close the water supply tap, unscrew the filler hose from the back of the washing machine
and make sure the “anti-sand” filter is clean and not blocked.
E3 (with display)
3 flashes of the LEDs
(without display)
The washing machine does not drain water.
Make sure the filter is not clogged
Make sure the drain hose isn’t bent, kinked or trapped.
Make sure the home drainage system is not blocked and is allowing water to flow
through without obstruction. Try to drain the water in the sink.
E4 (with display)
4 flashes of the LEDs
(without display)
There is too much foam and/or water.
Ensure the correct amount of detergent is being used and the
detergent is designed for use in a washing machine.
E7 (with display)
7 flashes of the LEDs
(without display)
Door problem.
Make sure the door is correctly closed.
Make sure the clothes inside the drum are not preventing the door
from closing fully.
If the door is locked, turn off and unplug the washing machine from
the electrical supply socket, wait 2-3 minutes and reopen the door.
Any other code
Turn off and unplug the washing machine, wait a minute. Turn on the
machine and restart a programme. If the error occurs again contact an
Authorised Customer Service Centre directly.
