GB
10
A
Open door button
Press the button to
open the door
. Chapter 5 – Washing
instructions – explains how the door works and how to use it.
B
ON-OFF and washing
programme selection knob
This knob lets you:
•
switch the machine on and off by moving it in either
direction from the
OFF
position (knob indicator
vertical)
•
select
washing temperatures
within the various
fabric
sectors
by turning it in both directions
The knob does not move while the programme is running.
The programme is electronically controlled by the machine.
C
Time remaining shown on
display LED
Time remaining
This LED indicates that the display is showing the total
duration of the selected programme before the programme
starts, and the time remaining while the programme is
running.
D
Spin speed shown on
display LED
This LED indicates that the display is showing the maximum
spin speed for the selected programme. It stays on while spin
speed is being selected with the relative button.
E
Heating phase LED
During the heating cycle, this LED indicates that the
programme is in the washing water heating phase.
F
Display
The display shows the following information:
1.
time remaining
for the selected programme, given
hours/minutes.The stated value is an estimate based on the
achine's normal operating parameters (size of load, incoming
ater temperature, etc.). The program time may therefore be a
w minutes longer or shorter than stated here.
2.
delayed start
(for models featuring this option).
iven in hours/minutes. When the time remaining before the
rogramme starts is less than 60 minutes, this information is
ven in minutes/seconds.
3.
spin speed
4.
cycle pause
- flashing STOP
5.
end of cycle
- END
6.
error codes
To find out which of the first 3 pieces of information are
hown on the display, check which of the LED's, C, D, or N (the
tter for models featuring the delayed start option) is lit.
G
Select spin speed button or
stop with tub full
Press the button repeatedly to select the required spin
speed. The following spin speeds are available:
•
0000:
spin disabled and stop with tub full. The
machine does not perform the final spin and ends the
washing programme with water in the tub. To drain
the water, see the explanations shown in paragraph
5.14
•
from 600 rpm to the maximum speed indicated for
