Instruction manual Wi6160
Please keep this instruction manual for future reference
21
Note:
The furniture door can extend beyond the appliance door, however you must
ensure a gap of atleast 75mm must be left from the bottom of the furniture door to
the floor to allow for sufficent ventilation.
HOW TO INSTALL THE FURNITURE DOOR
Note:
If a handle is required, please ensure this is installed in an appropriate
position before the furniture door is installed.
1. Fully open door.
2. Starting at the corner, pull the gasket away from the door. As per Fig A.
3. Continue to pull the gasket free from the gasket channel.
4. Upon removal, lay gasket down on a flat surface.
5. Secure the furniture door panel to the appliance door using clamps (see Fig. B).
6. Using a 3 mm drill bit, drill 6 pilot holes into the wood panel 12 mm deep using
the holes in the door frame as a guide.
Note:
It is important to ensure that all drilled holes are drilled to the correct depth
in order to avoid splits in the wood when hardwood is installed. You must also
take care not to drill all the way through the door.
7. Locate 6 of the M4x34 mm screws provided with your unit.
8. Using a Phillips screwdriver, place one screw into each of the 6 pilot holes and
screw into the door, as per Fig C. Be careful not to over tighten screws. Ensure the
screws sit flush against the bottom of the channel. Remove clamps from door.
Note:
If panel requires additional adjustment after removing clamps, slightly
loosen each screw and adjust panel as necessary. Tighten screws upon
completion.
10. Starting at the corners, re-install the gasket into the gasket channel in the
frame, by pushing firmly into place. Make sure the gasket is fully seated into the
channel.
Wi6160 Wine Cabinet Instruction Manual.indd 21
25/09/2018 16:03
