Instruction manual WDU060, WDU080 & WDU125 9
Please keep this instruction manual for future reference
› If you use putty or silicone instead of the gasket,
form a ring around underside of sink flange (see
3D). Insert flange into sink opening, press down
hard to squeeze out excess putty or silicone (see
3B). From under sink, trim off excess putty or
silicone flush with bottom edge of sink opening.
› From underneath sink, slip fibre gasket onto
exposed sink flange. With arrows pointing up,
screw support ring onto the sink flange, hand
tighten until the sink flange will not move. At this
point you may want to insert stopper in sink and
fill with water to check sink flange seal and ensure
there are no leaks.
› Place mount ring over sink flange and hold in place
while installing cushion mount (large side down)
so the groove on the inside of cushion mount fits
over lip on sink flange, similar to putting the lid on
a plastic container (see 3E, 3F & 3G). Please read
important notice below.
› The disposer must be installed so that the reset
button is readily accessible.
TOP OF SINK FLANGE
FIBER
GASKET
RUBBER
GASKET
SUPPORT
RING
SINK
FLANGE
SINK
BOTTOM
BEAD OF
CUSHION
MOUNT
OPEN AREA, NO
OBSTRUCTION
MOUNT RING
SHOULD BE FREE TO
MOVE UP & DOWN
3D
3F
3E
I M P O R TA N T N O T I C E :
C U S H I O N M O U N T D E TA I L
When the cushion mount is installed correctly,
the lip of the sink flange fits into the groove on
the inside of the cushion mount and mount ring
can be pulled downward over cushion mount
and will be free to rotate. The bottom bead of
the cushion mount acts as a gasket between
the bottom of the sink flange and the top of the
disposer. See illustration 3G.
GROOVE
BOTTOM
“LIP” OF
SINK
FLANGE
MOUNT RING
SUPPORT
RING
SINK
BOTTOM
BEAD
CUSHION
MOUNT
3G
