Caple PI402, Instruction Manual

Page: 8 / 16

8
TIMING
As a result of the new EU65 “Energy label” and
EU66 “ Ecodesign” regulations issued by the
European Commission, which came into force as
from January 1st, 2015 , our products have been
adapted to comply with these new requirements.
All of the models complying with the energy label
requirements, are equipped with new
electronics including a timer device for speed
controls, when the air capacity exceeds 650m³/h.
Internal motor models, with maximum air
capacity higher than 650m³/h, are equipped
with a timer device that automatically switches
the speed from 4th to 3rd speed, after 5 minutes
operation.
External motor models are equipped with remote
motors that , as for internal motor versions,
include a timer device that switches down the
speed when it exceeds 650 mᵌ/h. (See External
Motors Instructions). Remote motors, whose air
capacity exceeds 650m³/h at both 4th and 3rd
speed, will have the following by default timer
control functions: The speed is automatically
switched from 4th to 2nd speed, after 6
minutes operation.
If the appliance is working at 3rd speed, it is
automatically switched to 2nd speed, after 7
minutes operation. Operation speeds can also
be changed during operation.
The energy consumption of the appliance in
standby mode is lower than 0.5W.
MAINTENANCE
* An accurate maintenance guarantees good
functioning and long l asting performance.
* Particular care is due to the grease filter
panel. It can be removed by pushing its
special handle toward the back-side of the
cooker hood and turning the filter downwards
so to unfasten it from its slot (Fig.3A).
This can be cleaned by hand with warm soapy
water, or cleaned in the dishwasher.
To insert the filter just perform the opposite
operation.
* In the case the appliance is used in
recirculation mode , the active c harc oal filter
(Fig.8Z) needs to be periodically replaced.
The char coal filter can be removed by
removing the grease filter first (Fig.3A), and
by pulling its special plastic tongue until it is
unfastened from its slot. Re i nsert the
char coal filter by operating in the opposite
way. The char coal filter (cCAP39CF) should be
replaced after every 6 months. however this
can depend on its use. replacement filters can
be purchased via our Caple website
www.caple.co.uk
* To clean the appliance itself tepid water and
neutral detergent are recommended, while
abrasive products should be avoided. For
steel appliances specialized detergents are
recommended (please follow the instructions
indicated o n the product itself to obtain the
desired results).
* Before replacing the lamps, disconnect the
appliance from the electric mains. Remove
the grease filter and the carbon filter, if it is
inserted. Once the burnt out bulb is localized,
turn it anticlockwise and replace it with a
bulb of the same type.
To replace and remove the led lamp, (Fig.9)
remove the lamp by inserting a screwdriver or
another sharp tool between the lamp and its
chrome support. replace with a lamp of the
same kind.
* If the supply cord is damaged, it must be
replaced by the manufacturer or its sevice
agent or a similarly qualified person in order
to avoid a hazard.