8
Fix the hob with the relevant fixing clamps and screws, as shown in the diagram. When the screws have been tightened, the excess
seal can be removed.
(See Figure 7*)
The edge of the hob forms a double seal which prevents the build-up of liquids.
Check the hob after installation & before using
When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the step below,
---Turn the gas tap to MAX position and ignite
---Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable or is
extinguished follow the procedure below.
Procedure:
---Re-ignite the burner and set to MIN.
---Remove the control knob and use a thin bladed screwdriver to turn the adjustment screw until the flame is steady and does not
extinguish, when the knob is turned from MIN to MAX.
---Repeat the adjustment procedure for all burners.
Pressure Testing:
--
-Remove left hand pan support and front left burner cap and crown.
---Fit manometer tube over the injector.
---Turn on the burner gas supply and ignite another burner.
---Turn off the burner supplies.
Conversion form NG to LPG or from LPG to NG
Important
The replacement / conversion of the gas hob should only be undertaken by a competent person.
It is important to note that this model is designed for use with which gas category. Please check the note on the appliance. But it can be
converted from one gas category to another providing the correct injectors are fitted and the gas rate is adjusted to suit.
Method
l
Ensure that the gas taps are in the
” position
l
Isolate the hob from the electrical supply
l
Remove all pan supports, burner caps, rings, crowns and control knobs
l
With the aid of a 7mm box spanner the burner injectors can then be unscrewed and replaced by the appropriate injectors.
To adjust the gas rate
With the aid of a thin bladed screwdriver completely tighten down by the pass adjustment screw, which is located down the center of the
gas tap control shaft. Upon completion stick the replacement rating plate on the under side of the hob.
Figures
Figure 1 Figure 2
Summary of Contents for C742G
Page 1: ......
Page 9: ...9 Figure 3 Figure 4 Figure5 Figure6 Figure7 Figure8 ...
