4
INSTRUCTIONS FOR THE INSTALLER
IMPORTANT NOTICE:
THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY QUALIFIED PERSONNEL
EXCLUSIVELY, IN CONFORMITY WITH THE REGULATIONS IN FORCE.
THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES TO PEOPLE, ANIMALS
OR THINGS, RESULTING FROM THE FAILURE TO COMPLY WITH SUCH PROVISIONS.
INSTALLATION
Installing the top
The appliance is designed to be embedded into
heat-resistant pieces of furniture.
The walls of the pieces of furniture must resist a
temperature of 75°C besides the room one.
The equipment must not be installed near
inflammable materials, such as curtains,
cloths,etc.
Make a hole in the top of the piece of furniture,
with the dimensions indicated in fig.3, at a
distance of at least 50 mm from the appliance
border to the adjacent walls.
MODEL
L (mm)
P (mm)
C971G
845
495
C1071G
1080
280
Any possible wall unit over the cook-top must
be placed at a distance of at least 760 mm from
the top.
It is advisable to isolate the appliance from
the piece of furniture below with a separator,
leaving a depression space of at least 10 mm
(fig. 4).
If the hob is going to be installed on the top
of an oven, precautions must be taken to
guarantee an installation in accordance with
current accident prevention standards. Pay
particular attention to the position of the
electric cable and gas pipe: they must not touch
any hot parts of the oven.
Moreover, if the hob is going to be installed
on the top of a built in oven without forced
cooling ventilation, proper air vents must be
installed to guarantee an adequate ventilation,
with the lower air entering with a cross section
of at least 200cm
2
, and the higher air exiting
with a cross section of at least 60 cm
2
.
Fastening the top
Every cook-top is equipped with a special
washer.
A set of hooks is also supplied for mounting the
cook-top.
Depending on the type of mounting surface,
the suitable type of mounting hook is supplied.
For the installation proceed as follows:
-
Remove the racks and burners from the top.
-
Turn the appliance upside down and lay the
washer S along the external border (fig. 5);
-
Mount hooks and block with the screws V (fig.
6);
-
Introduce and place the cook-top in the hole
made in the piece of furniture, then block
it with the C screws of the fastening hooks
(fig.6/A).
Installation room
This appliance is not provided with a device for
exhausting the products of combustion.
Regarding room ventilation rules where
appliance is installed make reference to
the legislation, in conformity with the local
regulations.
Summary of Contents for C1071G
Page 6: ...6 1 2 3 4 CLOSE MAXIMUM MINIMUM 5 6 6 A 7 F 10 9 8 ...
Page 9: ...9 ...
Page 10: ...10 ...
Page 11: ...11 ...