CapKold CKPF/3, Operator'S Manual

Page: 24 / 32

24 OM-CKPF/3
The CapKold CKPF/3 Mobile Pump/Fill Station is designed to operate smoothly and efficiently when properly maintained. The following is a list of
checks to make in the event of a problem. Wiring diagrams are furnished inside the service panel and later in this manual. If an item on the check
list is marked with an (X), it means the work should only be performed by an Authorized Service Agent (ASA). Reference material for options to the
CapKold CKPF/3 Mobile Pump/Fill Station are also included with this manual. Refer to the reference material instructions if problems arise.
SYMPTOM WHO WHAT TO CHECK
Unit will not pump. User
a. Pull the emergency STOP switch out
b. Turn the air switch ON.
c. Check to see if the cabinet lower front panel is correctly installed.
d. Plug in the unit and connect the air lines.
e. Prime the food transfer hoses with water.
f. Check that valve on the kettle underside is OPEN.
g. Check the control panel to make sure the pump/fill is in the AUTO, CONTINUOUS
or MANUAL mode.
h. Check the pump motor for damage (X).
i. Check the drop-down/ball valve for damage (X).
Tipper Tie clipper will not
operate.
User
a. Check for jammed clips and remove them.
b. Turn the air switch ON.
c. Check the air pressure – a minimum of 90 PSI is needed.
d. Check the loader to see if there are clips.
e. If the Temp Assurance option is installed, is the product temperature below the
set point?
f. Inspect the Tipper Tie for damage (X).
g. Check the oil level in the lubricator.
i. Check that the FRL is plugged in.
Bags fill to fast/too slow. User
a. Adjust the fill volume on the control panel.
b. Check food transfer hoses for blockage.
Hoses leaking. User
a. Replace worn, damaged or missing gaskets.
b. Tighten nuts and tri-clamps.
Troubleshooting