6
The TimeClock provides a trigger connector to a siren interface: Relay 1 (shown in the
picture below on the left). The Siren Relay Trigger Connector pin connectors as seen
from in the picture from top to bottom are:
o
Pin 1 and 2 – Normally Closed connection
o
Pin 2 and 3 – Normally Open Connection
The trigger connector is rated for 12 Volts DC.
Place the front cover on the back plate and clip the top end in. Lower the bottom of
the casing onto the back plate and fasten the two screws at the bottom of the clock.
The siren relay indicated in yellow in the picture on the left. A siren interface is connected to
the relay in a NO configuration in the picture on the right.
