52
53
EN
Check again for bearing play. Tighten by an-
other half turn, if necessary, and check again.
Do not tighten the bearing too much.
Check the bearing for ease of running, by lift-
ing the front wheel and by moving it.
Adjusting the headset requires a
certain amount of experience and
should, therefore, be left to a skilled me-
chanic. If in doubt, ask an expert to adjust
your Canyon Speedmax CF SLX.
Re-position the stem faceplate and tighten
its clamp bolt to the indicated torque value
of 2 Nm.
ADDITIONAL ACCESSORIES
ADDITIONAL ACCESSORIES
TRI BOTTLE ADAPTER
This adapter allows the assembly of one to two
bottle cages behind/under the saddle. Before
mounting remove the rubber cover on the rear
side of the seat post. Tighten the clamp bolts
to the indicated torque value of 4 Nm.
Position one bottle cage on the adapter and
screw one clamp bolt respectively into the
two thread holes of the adapter by tightening
them to the indicated torque value of 4 Nm.
As an alternative you can also fasten the
“Triathlon Bottle Adapter 30degree“ or the
“Triathlon Twin Bottle Adapter“, and on top
of them one (within easy reach turned by 30
degrees) or two bottle cages (to the side). In
doing so also observe the indicated torque
value of 4 Nm for the clamp bolts.
CARBON SEATPOST TT
This seat post allows a positioning of the sad-
dle further to the rear. In case you take part
in a time trial competition under UCI regula-
tions, this may be necessary to observe the
provisions for the horizontal saddle position.
THE BRAKE SYSTEM
