1- Clean the valve and place the cylinder on the main body. See Fig 4.
2- Release the cylinder of the cylinder ring as shown in the figure. See Fig 5-1; then place
the cylinder on the cylinder. See Fig 5-2; then tighten the cylinder of the cylinder, See
Fig 5-3.
3- Connect the regulator and the cylinder as shown in Fig 6. Make sure there is no leakage
or damage (please refer to “Leak Test” on page 9 and how to check for damage as
described on page 4).
4- Disconnect the regulator and the
cylinder as shown in Fig 7.
LOCATION
SETUP
GAS CONNECTION
Your gas appliance must be installed on a flat, stable surface, away from any combustible
materials or construction.
Your gas appliance comes assembled, ready for a gas connection.
1- Remove the appliance from the box and place it on any level, outdoor,
non-combustible surface.
NOTE: Do not place this appliance on grass or dirt. These surfaces may prevent proper
safety venting.
2- Open the gas door and put the cylinder inside.
3- Unscrew the battery box as shown in Fig 1. Insert the negative electrode side of
the battery into the bottom of battery box as shown in Fig 2. Then screw the battery
box as shown in Fig 3.
Note: If the battery of the pulse electronic igniter runs out of power, please replace the
new battery as shown above.
8
Summary of Contents for LFT1224PST-A
Page 6: ...6 EXPANDED VIEW...
