Do not use an open flame to check for leaks.
Do not smoke during testing.
Do not test indoors.
A leak test must be performed whenever the gas cylinder is replaced.
!!!WARNING!!!
NOTE:
While in use, the burner flame should be mainly blue in appearance with a small
amount of yellow. The flame can be identified by the following figure.
1. Make sure the control knob is in the “OFF” position.
2. Make sure the gas cylinder is correctly and securely connected to the pressure regulator,
without over-tightening.
3. Turn on the gas cylinder valve. Apply a 50% soap and 50% water solution to the gas hose
and connections between the control knob and gas cylinder.
4. If something is leaking, you will see bubbles form. In case of leaks, turn off the gas supply,
undo the leaking connection, re-connect it and try again. If the leak persists, consult Customer
Service Centre for assistance (
1
-
888
-
670
-
6684
).
5. If the connection does not leak, continue to the next step.
1. Make sure the control valve is OFF.
2. Turn on the gas tank valve.
3. Press and turn the control valve knob counterclockwise to LOW
to light. See the figure to the right.
4. If the burner is lit, continue pressing in the control valve knob
for one minute to heat the thermocouple.
5. When the turn the control valve knob is released, the burner should
be lit. If not, turn the
control valve knob clockwise to OFF. Wait
5 minutes then start with step 3 above.
6. Press and the control valve knob to desired heat output,
LOW ~ HIGH.
LEAK TEST
9
MODEL N0. 085-1562
LFT1224PST-A
LIGHTING THE BURNERS
OPERATION AND LEAK TEST
OFF
HIGH
MAX
BAS
ARRET
LOW
Warning: Lighting the fire table improperly could lead to unsafe conditions.
7. Press and turn the control valve knob clockwise to OFF to shut down the fire pit.
Close the gas cylinder valve when the fire pit is not in use.
(
CAUTION:
Do not kink flexible gas hose. If it is kinked, a gas leak could occur.)
Summary of Contents for 085-1562
Page 6: ...6 EXPANDED VIEW ...
