17
DESCRIPTION OF PARTS
1. Oscillation knob
2. Switch knob
3. Motor
4. Power cord
5. Adjusting knob
6. Base
7. Base set screw
8. Rear guard
9. Set screw
10. Blade
11. Nut
12. Screw
13. Front guard
ASSEMBLY INSTRUCTIONS
1. After removing everything from the carton, locate the motor unit and separate the front guard and rear
guard if they are connected.
2. Locate the rear guard and align with the motor unit; the safety grille will only fit one way: with the handle
facing up. Insert the four locking screws and tighten to secure the rear guard to the motor unit.
3. Screw on the plastic nut tightly to attach the guard.
4. Loosen the set screw on the blade, slide the blade onto the shaft of the motor, tighten the set screw onto
the flat section of the shaft to secure the blade.
5. Assemble the front guard to the rear guard. Tighten the connecting screw and nut, and secure the retai-
ning clips.
6. Remove the set screw from the stand, offer up and align the base with the hole in the stand, insert the set
screw in the base and tighten.
BASE AND TUBE INSTRUCTIONS
The appliance does not need to be installed.
Fix the tube on the base plate using the screws.
Position the unit on a table.
