Canton Smart Vento 3, Operating Instructions Manual

Page: 79 / 106

3 81
English
To activate/deactivate this function, proceed as follows:
1
Select the Bluetooth
®
Menu according to the BT (Bluetooth
®
Menu) chapter and select the BTS function using the navigation buttons “ ” and “ ”.
2
Press the “+” button to activate the function (AUT)�
3
Press the “–” button to deactivate the function (MAN)�
Note:
Depending on the mobile device used, the speaker can also switch to the BT input when typing a message or with other system sounds
when the automatic function is activated� A time delay of 5 seconds is programmed to avoid continuous switching (e�g� on arrival of a
message)�
Note:
If the BTS function is activated (AUT), the BT input can no longer be selected via the “Input” button� In this mode, the speaker can be
paired with the mobile device, regardless of the selected signal input�
APL (Automatic Bluetooth ® Playback)
If this function is activated, the playback of a previously connected playback device with Bluetooth
®
wireless technology will automatically
start when the speaker is switched on using the “Power” button� This starts playback of the app last opened in the mobile device�
Enter the following to activate the function�
1
Select the Bluetooth
®
Menu according to chapter BT (Bluetooth
®
Menu) and select via the navigation buttons “ ” and “ ” the APL function�
2
Press the “+” key to activate the function (ON)�
3
To deactivate, press the “–” key�
Note:
Depending on the operating system of the mobile device and the app, the app must run in the foreground or at least in
the background� If there is no app or one that does not support background operation, playback will not start�
INF (Device Information)
This menu item provides information about the firmware of the device� For service inquiries, please provide this information�
To retrieve these, please proceed as follows:
Press the “M” button, SPS is displayed� Press the “ ” key until INF is displayed� Press the “OK” button and note the
displayed information�