Canton Smart Vento 3, Operating Instructions Manual

Page: 75 / 106

3 77
English
To change the value for the parameter ASM, proceed as follows:
1
Select the SYS menu as described in the chapter SYS (System Setup) and select the ASM function using the navigation buttons “ ” and “ ”.
2
Change the value using the “+/–” buttons:
DST = Cable connection between source and each individual speaker required�
SST = Cable connection only between source and master required�
SLC (Slave Connection)
By default, the audio signals between the master and the connected speakers are transmitted wirelessly� With this function, however, it is also
possible to transmit the audio signals via a digital coax connection� For this you must connect the digital coaxial output of the master with the
digital coaxial input of the slave via a RCA cable�
To transmit the signals via the cable connection, proceed as follows:
1
Select the SYS menu as described in the chapter SYS (System Setup) and select the SLC function using the navigation buttons “ ” and “ ”.
2
Change the value using the “+/–” buttons:
WRD = Signal is transmitted via the RCA cable
WLS = Signal is transmitted wirelessly�
RES (System Reset)
With this function (RES) you can reset the speaker to factory settings� To perform the reset, proceed as follows:
Attention:
ALL settings you have made, transmitted IR codes and paired mobile devices and speakers will be deleted�
1
Select the SYS menu as described in the chapter SYS (System Setup) and select the RES function using the navigation buttons “ ” and “ ”.
2
After you have pressed the “+” key, YES will appear in the display�
3
To complete the reset process, wait for 10 seconds� After this time, all settings will be deleted and all speakers enter standby mode�
4
To cancel the reset process, press the “+” button within the 10 seconds mentioned above� The display shows NO to confirm the abort�