3
101
English
To enable resp. disable the subwoofer output, please do the following:
1
To enter the menu, press the "M" button.
2
Use the " " or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
3
Select the menu item Sub Out and confirm with the "OK" button.
4
Change the setting Wired [WRD] or Off[OFF], in case Wireless [WLS] using the "+" or "–" button and confirm your selection with the "OK"
button.
5
To leave the menu, press the "M" button.
Lip sync [LIP]
The processing of video data in the TV or a videoprojector usually takes longer than the audio signal processing. Lip sync [LIP] allows you to take
corrective action when the sound out of the Soundbar 10 is not lip-synchronous with the image on the TV. The delay of the audio signal
reproduced can be set to max. 200ms (0.2 seconds), in steps of 10ms.
To adjust the delay, please proceed as follows:
1
To enter the menu, press the "M" button.
2
Use the
" "
or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
3
Use the
" "
or " " button to select the menu item Lip sync [LIP] and confirm with the "OK" button.
4
Change the delay time using the "+" or "–" button to a desired value and confirm with the "OK" button.
5
To exit the menu, press the Menu button "M".
Note:
Because of wirelessly connected (Smart) speakers the maximum possible delay may be lower than 200ms.
Max Volume [VOL]
You can limit the maximum settable volume with this (protective) function in such a way that the sound level (indicated in the OSD resp. LED display
of the Soundbar 10) can not be turned up above the set value. You can set the desired volume level from 1 to 70, where 70 represents the maximum
and the factory setting.
To change the maximum volume, do the following:
1
To enter the Menu, press the "M" button.
2
Use the
" "
or " " button to navigate into the menu System Setup [SYS] and confirm with the "OK" button.
3
Use the
" "
or " " button to select the menu
item
Max Volume [VOL] and confirm with the "OK" button.
4
Change the volume level between values between 1 and 70 using the "+" or "–" button. Then press "OK", again.
5
To exit the menu, press the "M" button.
