3
101
English
Note:
If you press this key on the remote control while the Amp 5.1 is in normal mode, the system switches directly to the HD1 (BDP)
input.
6
Press the desired key on the remote control. If the infrared code has been successfully stored by the system, [OK] is shown briefly in
the display resp. "Success" on the screen, followed by the next input.
7
If the code could not be learned, [FAI] appears briefly on the display resp. "Failed" appears on the screen to indicate that no code has
been stored. In this case [HD1] will still be displayed. Please try a lower or higher distance between the Amp 5.1 and the TV remote
control in case the process fails again. Alternatively, try to press the key on the TV remote shorter or longer.
8
If you do not want to assign a button to input HD1, you can select the next input (in this case HD2) by pressing the " " button. The "
" button takes you to the previous input.
9
If you do not press any button on the TV remote control within 15 seconds, the system returns to the IR Menu.
10
The BT input is the last entry in the list. After this input the system jumps back to the IR menu.
Note:
Due to the variety of infrared codes it is not possible to guarantee that every IR remote control signal can be learned by the Connect
5.1. Signals from radio frequency (RF) remote controls cannot be learned, generally!
IR Clear [CLR]
Use this function to delete all IR codes stored on the Amp 5.1.
To delete IR commands please do the following:
1
To enter the Menu, press the "M" button.
2
Use the
" "
or " " button to navigate to the menu System Setup [SYS] and confirm with the "OK" button.
3
Use the
" "
or " " button to select the IR Menu [IRM] and confirm with the "OK" button.
4
Use the
" "
or " " button to select the menu item IR Clear [CLR] and confirm with the "OK" button.
5
"Reset All" appears on the screen and [YES] appears on the display. Press the OK button on the Canton Smart remote to delete the
stored commands. The screen will display "Please Wait". The system will then return to the IR menu [IRM].
6
To cancel the operation, press the "M" key or press "OK".
HDMI CEC [CEC]
Consumer Electronics Control is a cross-market standardized protocol for controlling devices connected to the HDMI® inputs/outputs. By
default this function activated [ON].
