3
95
English
Equalization [EQ]
In this menu you can adjust the frequency response of the loudspeakers that are connected to the Smart Amp 5.1 to match the room conditi-
on. You can choose between 3 EQ-settings for each speaker resp. each pair of speakers. A free position in the room is the factory setting.
To change the equalizer settings for a specific speaker or pair of speakers please do the following:
1
To enter the menu, press the "M" button.
2
Enter the first menu item Speaker Setup [SPS] by pressing "OK".
3
Select the menu item Equalization [EQ] using the
" "
or " " button and confirm with the "OK" button.
4
Select the desired speaker by using the " " and " " button and confirm your selection by pressing "OK".
5
Choose between the 3 following settings:
•EQ1 for free positioning in the room.
•EQ2 for positioning close to a rear or side wall.
•EQ3 for positioning in a corner of the room.
6
Press the "M" button to go back to the selection list and repeat the process for the rest of speakers.
7
Press the "M" button to exit this menu item.
Xover Small Speakers [XOV]
With this menu item you can set the crossover frequency between a small or bookshelf speaker (Speakerconfiguration [SPC] = Small) and
a connected subwoofer. This function is only available if at least one of the connected speakers ist set as Small or if you are using small or
bookshelf Canton Smart speakers (Speakerconfiguration [SPC] = Smart), otherwise this function is grayed out. All speakers that are set as
Large (Speakerconfiguration [SPC] = Large) will receive the full audio signal without any filtering. Multiple crossover frequencies are available
between 40Hz and 200Hz. In general: The smaller a speaker, the higher the crossover frequency.
To set the crossover frequency between speakers and the subwoofer please do as follows:
1
Press the menu button "M" on the remote to enter the menu.
2
Confirm the first menu item Speaker Setup [SPS] by pressing the "OK" button.
3
Use the
" "
or " " button to select the menu item Xover Small Speakers [XOV] and confirm with the "OK" button.
4
Choose the desired crossover frequency using the "+" resp. the "–" key.
5
Press the "M" button to exit this menu item.
